The Main Interface Pictured below is the full interface.

The Command Buttons are located in the bottom left of the interface. You will use these to do most actions while designing your purfling.

Adding a Layer The Add button isa located in the lower left corner of the interface. By clicking this button you will add a new layer to the top of the purfling. You will then be able change it's material and height. Please note that there is a maximum number of six layers.

Setting the length of the purfling The button for setting the length of the purfling is located in the lower left corner of the interface. Clicking this button toggles the length of the purfling between 34.5" and 64".

Removing a Layer The remove button is located in the bottom left corner of the interface. Clicking this button will remove the topmost layer of the purfling.

Setting a Layer's Material The button to set a layer's material is located in the lower Left corner of the interface. After clicking this button a panel will appear with a selection of materials to choose. By clicking on one of the materials you will set the material of the selected layer.

Setting a Layer's Height The button to set the height of the current layer is located in the bottom left corner of the interface. When clicking this button a select box will appear in th upper left corner of the interface. It will display a list of the Heights this material is available in. If it does not appear then the material is only available to the shown height. Clicking on a height in the list will set the height of the current layer.

Setting the Width of the Pufling The button to set the width of the purfling is located in the the bottom left corner of the interface. When clicking this button a select box will appear in th upper left corner of the interface. It will display a list of the standard widths. Clicking on a height in the list will set the width of the purfling.

Selecting a Layer Located on the right hand side of the interface is the Layer Select Panel. to select a layer to set the material or height, click on the button whose number coresponds to the postion of the layer you want to modify. Selecting the "none" button will deselect any layer.